Your cart is currently empty!
Printers
Anything to do with the printers I have
-
Ultimaker Upgrade (Part 3: Getting Started)
Before I could get started printing I had to configure both Cura and the firware. I’m already running “Tinker Firmware” on my ultimaker and luckily there is a version available for dual extrusion. If you aren’t running this firmware already I would highly recommend it even if you don’t plan on an upgrade.. The only…
-
Ultimaker Upgrade (Part 2: The Build)
With the hardware assembled it was time for some electronics. For the most part this was just a case of plugging the correct component into the appropriate port however this did require disassembling the entire printhead and digging through the nest of wires that surround the printboard. The hotend was then reassembled and mounted back…
-
Ultimaker Upgrade (Part 1: The Plan)
This has been on my to do list since I first got the printer… The ultimaker 2 (and 2+) were originally designed to be dual nozzle printers. This means the board has an extra Heater, temperature sensor and extruder motor output. So the parts required are: PT100 Thermocouple 25W Heater cartridge (I was worried about…